Right now Im using Scupley original to make my models, but its a pain in the arse to try to get fingerprints out of. Lots of sanding, and Id like it better if it held its shape at room temp a bit better. Its a very soft clay which is both good and bad.
Ive picked up some 2oz packages of fimo soft, two different kato colors and some premo sculey. So far ive only played with the translucent kato, but its ridiculously hard to get kneaded and workable.
Any suggestions as far as that goes?
Im building armatures for my larger pieces and that helps but imnfinding it difficult to get details set in the sculpey without leaving fingerprints.
Anyway, who here works with this type of clay? I know Romy does so im hoping shell chime in here too
Ive picked up some 2oz packages of fimo soft, two different kato colors and some premo sculey. So far ive only played with the translucent kato, but its ridiculously hard to get kneaded and workable.
Any suggestions as far as that goes?
Im building armatures for my larger pieces and that helps but imnfinding it difficult to get details set in the sculpey without leaving fingerprints.
Anyway, who here works with this type of clay? I know Romy does so im hoping shell chime in here too